Calcium hydroxide production line

The first time we used the equipment of HCM, the overall effect was good. We bought a ring roller mill and a Raymond mill. In order to reduce the noise, we also specially installed a sound insulation room outside the main machine of the ring roller mill. The workshop was basically quiet and free of dust. It was very clean. The fineness of the product could meet the standard, but it did not run rough. This was very good.

It took a short time from ordering to delivery to installation, and I felt the efficiency and professionalism of Hongcheng people. I also visited other customers' sites of Hongcheng calcium hydroxide before, and the fineness and output of the products were good. There were five levels of lime digestion, which was quite thorough, and guaranteed the quality of our finished products. What we need to do is high-quality calcium lime powder.

We are a building decoration material factory, and have purchased the limestone vertical mill equipment of HCM and put it into production! The model of vertical limestone mill is HLM1500 vertical mill, which is used to process limestone for building materials. It produces 200 meshes of stone powder, with a passing rate of D90 and a mechanical capacity of 23 to 27 tons/hour.

For the 250 mesh lime vertical mill pulverizing project, we purchased HLM1100 vertical mill to configure the production line for putting into production, and produced 200-250 mesh power plant desulfurization lime powder with a capacity of 7 tons per hour. The HLM1100 vertical mill pulverizer has stable operation, low failure rate, high output, and low energy consumption, bringing greater economic benefits to our company. We highly recognize the quality and performance of HLM vertical mill pulverizer and Guilin Hongcheng's pre-sales and after-sales services.

We have purchased Guilin Hongcheng's activated coke vertical grinding production line. The vertical mill, with a diameter of 1 meter and 9 meters, grinds 200 mesh fine powder of activated coke. It is highly efficient and energy-saving, with PLC intelligent control, clean and environmentally friendly. It has been running stably, safely and reliably since it was put into production.

Recently, our company contacted Guilin Hongcheng to purchase silicon carbide micro powder Raymond mill and inquired about the model selection of silicon carbide micro powder Raymond mill. After material analysis and trial grinding, Guilin Hongcheng Technical Engineer selected HCQ1500 Raymond mill for our SiC micro powder project model. At present, the installation has been completed and the trial operation is in good condition. Due to the high hardness of silicon carbide materials, improved wear-resistant materials are used in vulnerable parts, which enable the raw materials to be evenly and fully thrown between the grinding roll and the grinding ring. In particular, it can reduce the impact of the raw materials directly sent to the grinding roll by the blade on the grinding roll, so that the service life of the grinding roll and the grinding ring can be extended, thereby reducing the equipment failure rate and operating costs.