ACCESSORIES

We are a building decoration material factory, and have purchased the limestone vertical mill equipment of HCM and put it into production! The model of vertical limestone mill is HLM1500 vertical mill, which is used to process limestone for building materials. It produces 200 meshes of stone powder, with a passing rate of D90 and a mechanical capacity of 23 to 27 tons/hour.

Our company has excellent limestone mineral resources that can be exploited for more than 200 years. This project mainly processes superfine calcium carbonate powder. We have discussed the equipment selection of the superfine mill for many times and visited the factory on the spot, and selected the HCH1395 calcium carbonate superfine mill of Guilin Hongcheng based on various factors. In the middle of 2014, we began to install, debug and operate it. At present, the ultra-fine pulverizer is running stably, and we are very satisfied with the output and fineness of the equipment.

It took a short time from ordering to delivery to installation, and I felt the efficiency and professionalism of Hongcheng people. I also visited other customers' sites of Hongcheng calcium hydroxide before, and the fineness and output of the products were good. There were five levels of lime digestion, which was quite thorough, and guaranteed the quality of our finished products. What we need to do is high-quality calcium lime powder.

On April 19, 2021, we ordered HLM1500 vertical pulverizer of nepheline mill from Hongcheng, which was officially put into operation. The HLM1500 vertical mill of Hongcheng is equipped with a grinding line to process nepheline and produce 200 mesh powder, with a passing rate of D90 and a single host capacity of about 8-9 tons. The equipment is stable, high yield, and the planned production index can be achieved!

Slag is a very ideal cementitious material for cement and concrete, which can save natural mineral resources and reduce carbon dioxide emissions, and has good economic and social benefits. Our company has built a new slag micro powder production line and selected Hongcheng HLM2800 vertical slag micro powder mill. At present, vertical slag micro powder mill is the ideal choice for slag micro powder grinding. It not only has low energy consumption, but also has good environmental protection and high intelligence.

Recently, our company contacted Guilin Hongcheng to purchase silicon carbide micro powder Raymond mill and inquired about the model selection of silicon carbide micro powder Raymond mill. After material analysis and trial grinding, Guilin Hongcheng Technical Engineer selected HCQ1500 Raymond mill for our SiC micro powder project model. At present, the installation has been completed and the trial operation is in good condition. Due to the high hardness of silicon carbide materials, improved wear-resistant materials are used in vulnerable parts, which enable the raw materials to be evenly and fully thrown between the grinding roll and the grinding ring. In particular, it can reduce the impact of the raw materials directly sent to the grinding roll by the blade on the grinding roll, so that the service life of the grinding roll and the grinding ring can be extended, thereby reducing the equipment failure rate and operating costs.