Calcium hydroxide production line

We are a Clean Energy Co., Ltd., and have purchased the HCM 200 mesh pulverized coal mill HLM1700 pulverized coal vertical mill. The unit hourly production capacity is up to 20 tons, and the pulverized coal production site is clean and tidy with low noise.

We are a manganese company. In the bidding for the harmless utilization of manganese slag solid waste project, a manganese slag deamination system (with a processing capacity of 40t/h) and two HLM slag vertical mills in Guilin Hongcheng won the bid. The manganese slag deamination system is used for electrolytic manganese slag deamination. The collected ammonia is cooled and turned into ammonia water for recovery; The rest of the electrolytic manganese slag is mixed with quicklime (5%), and then enters the HLM slag of Guilin Hongcheng, which is vertically ground to 200 mesh D90, and then calcined. After calcination, it will enter the clinker mill with other cement clinker to process to a specific surface area of 450m2/kg for concrete admixture.

We are a building decoration material factory, and have purchased the limestone vertical mill equipment of HCM and put it into production! The model of vertical limestone mill is HLM1500 vertical mill, which is used to process limestone for building materials. It produces 200 meshes of stone powder, with a passing rate of D90 and a mechanical capacity of 23 to 27 tons/hour.

Recently, our company contacted Guilin Hongcheng to purchase silicon carbide micro powder Raymond mill and inquired about the model selection of silicon carbide micro powder Raymond mill. After material analysis and trial grinding, Guilin Hongcheng Technical Engineer selected HCQ1500 Raymond mill for our SiC micro powder project model. At present, the installation has been completed and the trial operation is in good condition. Due to the high hardness of silicon carbide materials, improved wear-resistant materials are used in vulnerable parts, which enable the raw materials to be evenly and fully thrown between the grinding roll and the grinding ring. In particular, it can reduce the impact of the raw materials directly sent to the grinding roll by the blade on the grinding roll, so that the service life of the grinding roll and the grinding ring can be extended, thereby reducing the equipment failure rate and operating costs.

Half a year ago, our company's dolomite processing plant purchased two sets of HC1900 Raymond Mill for dolomite sand powder all-in-one machine produced by Guilin Hongcheng. Now the installation has been completed, and the trial operation inspection has been passed, and the project is officially put into production. One of them produces 250 mesh dolomite powder and dolomite sand, achieving a silt output of 36 tons/hour; The other set produces 280 meshes of dolomite powder and dolomite sand, achieving a silt output of 40 tons/hour. Compared with the separate production lines of our former sanders and grinders, this has greatly saved energy consumption and greatly improved production capacity!

Our company's HLM2800 large and new type of water slag vertical mill is a new type of water slag vertical mill above 2.2m built by HCM. The installation of the water slag micro powder preparation production line of the new type of water slag vertical mill has been completed recently! The main equipment used in this production line is HLM series water slag vertical mill, which is designed and constructed by HCM according to local conditions. This production line is scientifically and rationally designed, compact in layout, intelligent and environmentally friendly, which really makes us feel the economic benefits brought by the new equipment and new technology with high efficiency and energy conservation are incalculable!